Dispensing Tips for Filled Adhesives: Wear and Bore Sizing
A filled adhesive does not fail a dispensing tip the way a clog does. It fails it slowly and quietly: the deposit drifts larger over a shift, then over a week, until an operator notices that the same program and the same pressure are laying a bead 15% wider than the qualification run. By then […]
Dispense Tip Hub Types: Luer Lock, Bayonet and Push-Fit
The gauge gets specified. The geometry gets argued over. The hub gets whatever the buyer used last time. That is backwards, because the hub is the only part of the tip that has to match a component you already own, and it is where the two most common failures live: a tip that will not […]